On this page, cookies are needed if you want to use the full range of the page. Please activate cookies and refresh that page. After refresh a cookie management dialogs will be available.

The cookie settings on this website are set to 'allow only strictly necessary' to give you the very best experience. If you continue without changing these settings, you consent to this - but if you want, you can change your settings at any time at the bottom of this page.

 

Interface Modules


 
B201 2-Wire Powered Loop
  • Suitable for use with 2-wire smoke detectors and burglary devices
  • Supports up to 20 compatible smoke detectors
  • Resets latching devices from the control panel
  • Connects to the control panel terminal block with easy-to-install integrated pins
 
 
B810 Wireless SDI2 bus interface
  • Dual internal antennas provide spatial and polar RF signal reception for high reliability
  • Cover and wall tamper protection
  • Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
  • Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
  • External status LEDs
  • Detection and reporting of radio frequency interference
 

Features

BubbleLevel EasyInstall Indoor SDI2 Wireless
 
 
B430 Plug-in Communicator, Telephone
  • Provides a single telephone line with RJ-45 connection for central station reporting and remote programming
  • Easily configured for communications from Remote Programming Software (RPS) or a keypad, eliminating the need for separate configuration
  • Easy two-step plug-in installation, troubleshooting, and maintenance
 
 
C900V2 Dialer intercept communicator, Ethernet
  • Captures alarm and event data from dialer-based control panels using CONTACT ID, SIA, Modem II, Modem IIe, Modem IIIa2, Pulse, and other formats
  • Performs full data transmissions without changing the data
  • 12 VDC to 24 VDC voltage range
  • Re-routes signals using UDP/IP-based data networks
  • Convenient connection (RJ-45 Jack) to Ethernet networks
  • Integrated 10/100 Network Interface Module, or NIM
  • Provides acknowledgement from the receiver to the control panel
  • Supports 128-bit AES Rijndael encryption
 
 
D135A Low battery disconnect module
  • Disconnects a B6512/B5512/B4512/B3512 from the battery when the battery level drops to 9.5 VDC
  • Required for use with compatible control panels for CAN/ULC S559
  • Quick and easy installation
 
 
DX4010V2 USB/serial interface module
  • RS-232/USB connectivity
  • Enhanced direct connection for Remote Programming Software (RPS)
  • RJ-16 data bus
  • Transparent enclosure
  • Diagnostic light emitting diodes (LEDs)
  • DIP switches for address and bus programming
 
 
ITS-DX4020-G GPRS/GSM integrated communicator
  • Secure IP communication from compatible Bosch panels to Bosch receivers
  • Remote programming of IP compatible Bosch panels
  • GSM reporting from Contact ID control panels to any PSTN receiver
  • Easy provisioning using SMS (text) or USB
  • Easy installation, troubleshooting, and maintenance